How To Set Dewenwils Timer

dewenwils HODT12B Outdoor Remote Control Inaugural Timer Didactics Manual

Thank You for Your purchase.
Please contact the states if y'all accept any trouble.
E-mail: [email protected].
Please attach your User Name or Club ID and then that nosotros tin can assist you better.

CAUTION

Suitable for use with outdoor appliances.
For apply Just with a iii conductor GFCI protected outlet.
Raintight when mounted vertically with receptacles facing downward.
Do not immerse in water.
DO NOT EXCEED RATED CAPACITY.
The device must exist mounted in a vertical position with the receptacle facing downward and with the receptacle at least ii FT above the ground level.
Cord-connected Operating Command.
Temperature limits of the SWITCH Caput: -40-40ºC.

Installation

Mount or hang the RECEIVER on the wall near a GFCI protected outlet (125V 60Hz) which the power supply cord of the RECEIVER will plug into.
Plug the string of the device you wish to control remotely at the lesser of the RECEIVER.

Push button Layout

Sensor ( ):
Sensor will plow receiver on at dusk and off at dawn.
Operating Style:
Timer will turn ON, ii, 4, 6, or 8 hours afterwards dusk.
Select push button:
To select the role and repeatedly.
Power ON Sensor ( ) → 2H → 4H → 6H → 8H → OFF → ON
Outlets:
Plug the lights or devices to exist controlled by the timer into one of the outlets.
Transmitter

Opoerating Instructions

Receiver & Transmitter operation modes:

ON: Power is ON to attached devices Sensor ( Dusk – Dawn): power will turn on at dusk and remain on until dawn

ii Hrs: Power will plow on at dusk and remain on for 2 hours
iv Hrs: Power volition turn on at dusk and remain on for 4 hours
6 Hrs: Power will plough on at dusk and remain on for 6 hours
8 Hrs: Power volition turn on at dusk and remain on for 8 hours
OFF: Power is OFF to attached devices

Note for Transmitter: Command electric outlet upward to a distance of 100 anxiety.
Note The timer has daily repeat afterward setting, in case of ability failure, information technology will stop operating when the ability goes out. Once power is restored, reset the desired operating mode as the operating instructions.

Helpful Tips

When ready to "ON", the timer will provide continual power to fastened devices until the timer is switched to "OFF", or to any of the other operating modes.
In the sensor ( dusk-to-dawn) mode, temporary calorie-free sources similar headlights, porch lights and other external calorie-free sources will non interfere with the photocell role unless the external light source is on for more than 15 minutes. In that case, the timer volition shut off until darkness is restored. The improvement avoids the flickering.
One time programming activates at dusk in the 2hr, 4hr, 6hr, or 8hr style, the program cycle will complete before the timer resets. Headlights, porch lights, street lamps and other external lighting sources will not interfere with the agile timer plan.

Battery Handling and Usage

Install the battery observing the positive (+) side up equally indicated inside the battery compartment.
Never throw batteries into a fire. Do not expose batteries to fire or other rut sources.
Battery contains mercury. Do non put in trash. Recycle or manage as chancy waste material.

Battery Replacement

Remove the battery compartment comprehend away from the remote (see diagram beneath)
Remove the sometime bombardment and place a new Type 3V (CR2032) lithium battery into the bombardment compartment.
Ensure the battery is installed correctly with the positive (+) side up.
Supercede the battery compartment cover.
Dispose or recycle spent/discharged batteries in compliance with all applicable laws. For detailed information, contact your local solid waste authorisation.
Caution: Failure to properly marshal the battery polarity can crusade personal injury and/or holding damage.

WARNING:
Do non ingest the battery, Chemic Fire Hazard (The remote command supplied with) This product contains a coin/push cell bombardment. If the coin/button jail cell battery is swallowed, information technology can cause severe internal burns in merely two hours and can pb to death. Proceed new and used batteries away from children. If the battery compartment does not close securely, cease using the product and keep information technology away from children. If you lot think batteries might take been swallowed or placed within any part of the trunk, seek immediate medical attending.

Specifications

Practice NOT Attach A DEVICE THAT EXCEEDS THE UNIT RATINGS:
125 V ac sixty Hz,
15 A Resistive,
15 A General Employ,
k W Tungsten,
500 VA Electronic Ballast, one/2HP.
120 V air-conditioning, 60 Hz, 8.iii A Anchor

RECEIVER MODEL: TM-110
TRANSMITTTER MODEL: TR-034-7
FCC ID: PAGTR-034-7

Safety Data

Federal Communication Commission Interference Statement

This equipment has been tested and plant to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to endeavor to correct the interference by ane or more of the post-obit measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/Television technician for assistance.

This device complies with Part 15 of the FCC Rules. Performance is subject to the following 2 conditions: (i) This device may not cause harmful interference, and (two) this device must take any interference received, including interference that may cause undesired functioning.

FCC Circumspection: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

One Year Limited Warranty

Dewenwils warrants this product to be costless from defects in material and workmanship for a catamenia of one year from the date of purchase. Warranty is void if damage is caused by misuse or improper installation. Please contact us if you have whatsoever questions.

Email: [electronic mail protected].
Our dedicated customer service team will become back to y'all within 24 hours.

Antenna Type Max. Antenna Gain(dBi)
PCB printed antenna: 0

This device complies with Part fifteen of the FCC rules and Industry Canada license‐exempt RSS standard(due south). Operation is subject area to the post-obit ii weather: (one) this device may not crusade harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or change to this equipment. Such modifications or alter could void the user's potency to operate the equipment.

This radio transmitter (identify the device by certification number or model number if Category Two) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this listing, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.

This equipment has been tested and constitute to comply with the limits for a Class B digital device, pursuant to part fifteen of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and tin radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does crusade harmful interference to radio or tv set reception, which can be adamant by turning the equipment off and on, the user is encouraged to endeavour to correct the interference past one or more of the post-obit measures:

Reorient or relocate the receiving antenna.
Increase the separation betwixt the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for assistance.

The device has been evaluated to run across general RF exposure requirement.

Ezoic